Task 7: Connecting The Power; Front Panel Leds - Promise Technology VessRAID 1000i Série Guide De Démarrage Rapide

VessRAID 1000i Series Quick Start Guide

Task 7: Connecting the Power

Plug-in the power cord on the power supply on the back of the VessRAID
enclosure and switch on the power supply. If you have a redundant power supply,
plug-in both power supplies and turn on both power supplies.
When the power is switched on, the LEDs and LCD screen light up.

Front Panel LEDs

When boot-up is finished and the VessRAID subsystem is functioning normally:
• Power, Global Enclosure Status, and Global RAID Status LEDs display
green continuously.
• Controller Activity LED flashes green when there is controller activity.
• System Heartbeat LED blinks green seven times in three seconds, goes
dark for six seconds, then repeats the pattern.
Figure 16.VessRAID front panel LED display
Controller LEDs
When boot-up is finished and the VessRAID subsystem is functioning normally:
• Battery, and Controller status LEDs display green continuously.
• Ethernet LEDs display green or flash depending on your network
connection.
• iSCSI LEDs display green or flash depending on your data network activity.
Power
Global Enclosure Status
Global RAID Status
Controller Activity
Reserved
System Heartbeat
18