LGB 21211 Instructions De Service page 8

MAINTENANCE
Lubrication
The axle bearings/drive rod ends
should be lubricated occasionally
with a small amount of LGB Main-
tenance Oil (50019).
Cleaning
This model can be cleaned using a
mild detergent and gentle stream
of water. Do not immerse this
model.
Replacing the light bulbs
To replace the front or rear lantern
bulb, remove the ring around the
lantern lens. Carefully pry the lens
away from the lantern. Pull the
plug-in bulb out of the socket. Plug
a new bulb into the socket. Reas-
semble.
To replace the cab bulb, pull the
plug-in bulb out of the socket. Plug
a new bulb into the socket.
Replacing the smoke generator
(Fig. - )
- Remove the two screws at the
front of the gearbox near the
front coupler (1).
- Remove the two screws at the
back of the gearbox near the
rear coupler.
- Remove the hex screws each
side on the vertical side rod hol-
der, which is attached to the
chassis (2).
- Pull the entire gearbox unit out
of the chassis.
- Unplug the wires (black, white)
from the smoke generator from
the circuit board (3).
- Use a small flathead screwdri-
ver to carefully pry the safety
cover out of the smokestack.
- Use a small pair of pliers to grip
the center heating element of
the defective smoke generator.
Pull the smoke generator out of
the smokestack (4).
- Insert a new smoke generator.
Reconnect and reassemble.
Replacing the traction tire
- Use a small, straight-blade
screwdriver to gently pry the old
traction tire out of the wheel
groove.
- Gently warm the new traction
tire in a dish of warm water.
- Use a small, straight-blade
screwdriver to gently pry the
new traction tire into the wheel
groove.
- Make sure that the traction tire
is completely in the wheel
groove.
8
Replacing the motor
Attention! Improper service may
void your warranty. For factory aut-
horized service, contact an authori-
zed retailer or send this LGB pro-
duct to an LGB service station (see
Factory Service).
Remove the entire gearbox (see
Replacing the smoke generator).
Remove the two screws on the top
gearbox plate, and remove the
plate. Replace the motor. Reas-
semble.
Attention! If the motor is replaced,
generously lubricate the gears with
LGB Gear Lubricant (51020).
Replacing the brushes, pick-up
shoes and wheelsets
Attention! Improper service may
void your warranty. For factory aut-
horized service, contact an authori-
zed retailer or send this LGB pro-
duct to an LGB service station (see
Factory Service).
Remove the the four screws on the
bottom gearbox plate, and remove
the plate. Replace the necessary
parts. Reassemble.
Attention! If the wheelsets are
replaced, generously lubricate the
gears with LGB Gear Lubricant
(51020).
Attention! If the wheelsets are
replaced, make sure that the drive
rods do not bind (Fig. 4). Binding
can cause serious damage to the
model.
Maintenance parts
50010 Smoke and Cleaning
Fluid
50019 Maintenance Oil
50020 Special Tool Kit
51020 Gear Lubricant
62201 Standard Motor
63120 Brushes, 14mm, 16mm,
8 pack
63218 Standard Pick-Up
Shoes, 2 pack
65853 Smoke Generator, 5V
68511 Plug-In Bulb, Clear, 5V,
10 pack
69104 Traction Tire, 37.5mm,
10 pack
4