Low Power - Shindaiwa PB 3410 Manuel D'utilisation

Troubleshooting Guide (continued)
What To Check
Is the engine overheating?
Engine is rough at all speeds.
May also have black smoke
and/or unburned fuel at the
exhaust.
Engine is knocking.

LOW POWER

Possible Cause
Operator is overworking the unit.
Carburetor mixture is too lean.
Improper fuel ratio.
Fan, fan cover, cylinder fins dirty or
damaged
Carbon deposits on the piston or in the
muffler.
Clogged air cleaner element.
Loose or damaged spark plug.
Air leakage or clogged fuel line.
Water in the fuel.
Piston seizure.
Faulty carburetor and/or diaphragm
Overheating condition.
Improper fuel.
Carbon deposits in the combustion
chamber.
Valve clearance set incorrectly.
Remedy
Cut at slower rate.
Consult with an authorized servicing dealer.
Refill with clean fresh unleaded gasoline
with a pump octane of 87 or higher, mixed
with Premium 2-cycle mixing oil at a 50:1
gasoline/oil ratio.
Clean, repair or replace as necessary.
Consult with an authorized servicing dealer
Clean or replace the air filter
Tighten or replace the spark plug. Restart.
Check the Product Specifications page in
this manual for the correct spark plug for
this unit.
Repair or replace fuel filter and/or fuel line.
Refill with fresh fuel/oil mixture.
Consult with an authorized servicing dealer.
Consult with an authorized servicing dealer.
Check fuel octane rating; check for presence
of alcohol in the fuel. Refuel as necessary.
Consult with an authorized servicing dealer.
17