Publicité
Les langues disponibles
Les langues disponibles
en
15
Notes on sanding.
Press the power tool with the sanding sheet
briefly and firmly against a flat surface and
briefly switch the power tool on. This pro-
vides for good adhesion and prevents prema-
ture wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached, turned by 120°.
Work with the entire surface of the sanding
plate, not only with the tip.
When sanding with the triangle sanding plate,
select a high oscillating frequency (electronics
level 4 – 6); when sanding with the round
sanding plate, select a moderate oscillating
frequency (max. electronics level 4).
Sand with continuous motion applying mod-
erate pressure. Applying excessive pressure
does not increase the rate of removal, it only
wears off the sanding sheet faster.
Notes on profile sanding.
Select a medium oscillating frequency.
Notes on sawing.
Select a high oscillating frequency. Round saw
blades can be released and clamped offset
again, to allow for uniform wearing off.
Notes on scraping.
Select a moderate to high oscillating fre-
quency.
Publicité
