Publicité
Les langues disponibles
Les langues disponibles
en
12
Changing the tool (figure 3).
For all work or when changing
CAUTION
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
The application tool can be offset in 45° steps
and fastened in the most favorable working
position.
Protect your hand and fingers
CAUTION
against bruising when locking
the clamping lever. The clamping lever snaps
back vigorously by means of spring force.
Fig. 3
45°
90°
0°
90°
45°
180°
180°
Release the clamping lever and tilt it to the
stop.
Pull out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Firmly press in the fastening element to
the stop. Then lock the clamping lever.
180°
45°
45°
0°
180°
Publicité
