Disposal And Environmental Protection - mspa MONO C-MO04 Manuel D'utilisation

For air leak from inside the valve
A. Disassemble the valve and check the position.
B. Disassemble the sealing rubble on the valve and clean both.
C. Assemble the valve back.
D. Inflate the SPA.
E. Tighten the valve further and inflate to recommended air pressure.
Storage and Prepare for the Next Time Use
1. Drain and clean the spa by following the
"Drainage" and "Spa Cleaning" sections
2. Reserve the set up instructions to deflate and
disassemble the spa tub, spa control unit and air
bladder
3. Make sure all the spa components and
accessories are thoroughly clean and dry before
storage. Air-dry the spa tub in the mild sun for
an hour before folding
4. Fold the spa tub loosely and avoid any sharp
corners to prevent damage or leakage to the spa
liner
5. Prepare new additional cartridge for next time use
6. Store the spa and accessories in a dry, temperature controlled, between 0°C- 40°C(32°F- 104°F) storage
location
7. Original packaging is recommended to be used for storage

DISPOSAL AND ENVIRONMENTAL PROTECTION

NOTE: Correctly use the wrench by pressing it with one hand on top.
This marking indicates this product should not be disposed with other household
wastes. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. You can obtain information on disposal from your local authorities.
To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for
environmental safe recycling.
SUN
20
®