Useful Adjustment Settings; Switching The Vertical Drive Frequency; Adjusting Image Positions; Selecting An Input Signal Type - Pioneer PDP-506FDE Mode D'emploi

Useful Adjustment Settings

09
Useful Adjustment Settings

Switching the vertical drive frequency

You can switch the vertical drive frequency for screen display
between 75 Hz and 100 Hz. Choose the drive frequency that
better suits your broadcasting signals.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Drive Mode" ( /
4
Select 75 Hz or 100 Hz ( /
Drive Mode
75Hz
100Hz
5
Press HOME MENU to exit the menu.
NOTE
• This setting can be made for each input source separately.
• This setting cannot be made when 480i, 480p, 1080i@60Hz,
720p@60Hz, or 1080p@24Hz signals are input.
• If you select "Auto" for "Side Mask" (page 38), the selection
for "Drive Mode" becomes ineffective.

Adjusting image positions

Adjust the horizontal and vertical positions of images on the
Plasma Display.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Position" ( /
4
Select "H/V Position Adjust" ( /
Position
H/V Position Adjust
Reset
5
Adjust the vertical position ( / ) or the horizontal
position ( / ).
6
Press HOME MENU to exit the menu.
NOTE
• To restore the factory defaults for all items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
• Adjustments are stored separately according to input
source.

Selecting an input signal type

After connecting to the INPUT 1, INPUT 2, or INPUT 3 terminal,
specify the type of video signals to be received from the
connected equipment. For the type of the signals, see the
operation manual that came with the connected equipment.
36
En
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
/
/ to select "Yes", and
Before starting the menu, press INPUT 1, INPUT 2, or INPUT 3
on the remote control unit or press INPUT on the Media
Receiver to select an input source.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Input Select" ( /
4
Select a signal type ( /
Input Select
Video
S-Video
RGB
COMPONENT
• For INPUT1, you can select Video or RGB.
• For INPUT2, you can select Video or S-Video or
COMPONENT.
• For INPUT3, you can select Video, S-Video, or RGB.
5
Press HOME MENU to exit the menu.
NOTE
• If no image appears or images appear in inappropriate
colours, specify another video signal type.
• For the signal types to be specified, check the operation
manual that came with the connected equipment.

Colour system setting

If an image does not appear clearly, select another colour
system (e.g., PAL, NTSC).
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Colour System" ( /
4
Select a video signal system ( /
Colour System
Auto
PAL
SECAM
NTSC
4.43NTSC
• You can select "Auto", "PAL", "SECAM", "NTSC", or
to
"4.43NTSC".
• With "Auto" selected, input signals are automatically
identified.
5
Press HOME MENU to exit the menu.
NOTE
• The factory default is "Auto".
• You need to perform colour system setting for each of INPUT
1 to 4.
• For the colour system setting, see steps 11 and 12 under
"Using Manual Adjust" (page 28).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).