Using I/O Link.a; Watching A Dvd Image; Connecting A Dvd Player; Displaying A Dvd Image - Pioneer PDP-506FDE Mode D'emploi

Masquer les pouces Voir aussi pour PDP-506FDE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Enjoying through External Equipment
10

Using i/o Link.A

The Plasma Display System incorporates three typical i/o
Link.A functions for smooth connections between Media
Receiver and other audiovisual equipment.
One Touch Play
While the Plasma Display System is in standby mode, it
automatically turns on and plays back images from the
audiovisual source (e.g. VCR, DVD).
WYSIWYR (What You See Is What You Record)
When the remote control unit of the connected VCR has the
WYSIWYR button, you can automatically start recording by
pressing the WYSIWYR button.
Preset Download
Automatically transfers channel preset information from the
tuner on the Plasma Display System to the one on the
connected audiovisual equipment (e.g. VCR) via the INPUT 2 or
3 terminal.
NOTE
• The i/o Link.A functions work only when the audiovisual
equipment is connected to the INPUT 2 or 3 terminal on the
Media Receiver with i/o Link.A via a fully wired 21-pin SCART.
• Either INPUT 2 or 3 is available for i/o Link.A, depending on
the switch on the rear of the Media Receiver.
• Using this switch, select the input terminal to which
recording equipment such as a VCR has been connected.
• Refer to operation manuals of each external equipment for
the details.
• If a SCART cable has been connected to the INPUT 3
terminal with the i/o Link.A activated, input signals (other
than Component) are automatically identified and displayed.
If the i/o Link.A has been deactivated, Video is always
selected for signals other than RGB because the system
cannot identify among RGB, Y/C (S-Video), and CVBS (Video)
signals; for example, receiving Y/C (S-Video) signals results
in monochrome display.
42
En
Media Receiver (rear view)
SERVICE ONLY
INPUT 1
ANT
I /o link.A
SELECT
INPUT
2
3
INPUT 2
or
i / o link.A
SELECT
SCART cable
INPUT
(commercially available)
2
3
VCR or DVD Recorder

Watching a DVD image

Connecting a DVD player

Use the INPUT 2 terminal when connecting to a DVD player
and other audiovisual equipment.
Media Receiver (rear view)
SERVICE ONLY
INPUT 1
ANT
I /o link.A
SELECT
INPUT
2
3
INPUT 2
SCART cable
(commercially available)
When using component cable,
select "COMPONENT" for
"Input Select" in the menu.
See page 36.
At the same time connect a
SCART cable to input audio
signals.

Displaying a DVD image

To watch a DVD image, press INPUT 2 on the remote control
unit or press INPUT on the Media Receiver to select INPUT2.
NOTE
• If DVD images do not come in clearly, you may need to
change the input signal type setting using the menu. See
page 36.
• Refer to your DVD player operation manual for the signal
type.
INPUT 2
R -AUDIO -L
Y
P
P
B
R
COMPONENT VIDEO
AUDIO OUTPUT
INPUT 3
HDMI
INPUT 2
R -AUDIO -L
Y
P
B
P
R
COMPONENT VIDEO
AUDIO OUTPUT
INPUT 3
HDMI
BLACK
WHITE
SYSTEM CABLE
Component cable
(commercially
available)
DVD player

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pdp-436fde

Table des Matières