Watching Tv; Turning On/ Off The Power - Pioneer PDP-506FDE Mode D'emploi

Watching TV

Watching TV
Unless you set up TV channels that you can watch under the
current conditions, you cannot tune in those channels. For the
procedure, see "Setting up TV channels automatically" on page
27.

Turning on/ off the power

NOTE
• When the Media Receiver is plugged into a power outlet, it is
placed into the standby mode; the STANDBY indicator on its
front panel should flash red. The Media Receiver stays in the
standby mode unless it is unplugged from the power outlet.
To turn on the system, press POWER on the Plasma Display.
• The POWER ON indicators on the Plasma Display and Media
Receiver light up in blue.
To turn off the system, press a on the remote control unit or
STANDBY/ON on the Media Receiver.
• The Plasma Display and Media Receiver are placed into the
standby mode; their respective STANDBY indicators light up
in red.
• You can then turn on the system again by pressing a or 0 to
9 on the remote control unit or STANDBY/ON on the Media
Receiver. If you press 0 on the remote control unit, images
come from the INPUT 1 source. If you press 1 to 9, TV images
display.
You can also press POWER on the Plasma Display to turn off
the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit and
Media Receiver.
NOTE
• If you are not going to use the Plasma Display System for a
long period of time, be sure to remove the power cord from
the power outlet.
• When the system is placed into the standby mode, the main
power flow is cut and the system is no longer fully
operational. A minute flow of power feeds the system to
maintain operation readiness.
Plasma Display/Media Receiver status indicators
The table below shows the operational status of the Plasma
Display System. You can check the current status of the system
with the indicators on the Plasma Display and Media Receiver.
Indicator Status
Plasma Display
POWER ON STANDBY
Flashing
For other than the above, see "Troubleshooting" on page 46.
Media Receiver
POWER ON STANDBY
The power cords of both the Plasma Display and the Media Receiver have been
disconnected. Or, the power cord of the Plasma Display has been connected but
the POWER button of the Plasma Display is off.
Power to the system is on.
The system is in the standby mode.
The power cord of the Media Receiver has been disconnected.
Power to the Plasma Display is off. Or the power cord of the Plasma Display has
been disconnected.
Flashing
Plasma Display
STANDBY indicator
POWER ON indicator
POWER button
Media Receiver
ON STANDBY
STANDBY/ON
STANDBY indicator
POWER ON indicator
STANDBY/ON
System Status
06
PULL
OPEN
21
En