Olympus LINEAR PCM RECORDER LS-10S Mode D'emploi page 52

7
Press the `/OK button.
8
Press the 2 button to select [Start].
9
Press the `/OK button.
4
• After the [Data will be cleared] message is
on for two seconds, [Cancel] will turn on.
10
Press the 2 button again to select
[Start].
52
11
[Cancel] will appear on
the display
• When an SD Card is inserted in the recorder,
• When attempting to perform operations such as
• Never perform operations such as the following
• Never format the recorder from a PC.
• Once the recorder is formatted, the music files
Menu Setting Method
Press the `/OK button.
• Formatting begins and [Format !] flashes
on the display.
• [Format Done] appears when formatting
ends.
Notes
be sure to confirm the recording media as either
[Built-in Memory] or [SD Card] so that there is
no mistake (☞ P.41, P.46).
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card (☞ P.18).
while processing, as they may damage the
data. In addition, replace the batteries with two
new ones in order to ensure that the batteries
will not run out while processing.
1 Turning off the power while processing.
2 Removing the batteries while processing.
3 Remove the SD Card during processing
when [SD Card] is being used as the record-
ing media.
Performing any of these operations may dam-
age the data.
with DRM may not be transferred to the recorder
again.