Using A Chargepak; About Chargepaks; Inserting A Chargepak - PURE Evoke H3 Manuel D'utilisation

Using a ChargePAK

About ChargePAKs

A ChargePAK is a rechargeable battery pack that allows you to listen to your music anywhere. When
your Evoke H3 is connected to a power outlet, it charges the ChargePAK. You can then disconnect your
Evoke H3 from the power and take your music with you.

Inserting a ChargePAK

Note: Your Evoke H3 is only compatible with a Pure ChargePAK B1. Do not use any other batteries or
ChargePAK models with your Evoke H3.
To insert a ChargePAK:
1. Switch your Evoke H3 off and disconnect it from the power supply.
2. At the back of your Evoke H3, press the two clips on the battery cover to remove it.
3. Insert the ChargePAK connector into the socket in the battery compartment.
4. Insert the ChargePAK into the battery compartment with the Pure label facing you.
5. Replace the battery cover.
6. Connect your Evoke H3 to the power supply.
The ChargePAK starts charging. If the ChargePAK is new or has not been used for a long time, we
recommend you charge it for at least 24 hours.
Note: When the ChargePAK is charging, it is normal for it to get warm. The efficiency of the
ChargePAK may decrease over time.
20
– +
5.5V DC 1A Aux in
>
– +
5.5V DC 1A Aux in