Kinderkraft Nubi Guide D'utilisation page 21

IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE
REFERENCE.
A. Safety and care notes
WARNING!
• Never leave the child unattended.
• Ensure that all the locking devices are engaged before use.
• To avoid injury ensure that the child is kept away when
unfolding and folding this product.
• Do not let the child play with this product.
• Always use the restraint system.
• Check that the pram body or seat unit or car seat attachment
devices are correctly engaged before use.
• This product is not suitable for running or skating.
• Age and weight usage: from 0 months up to 15 kg.
• We recommend using lowest reclined position for newborn babies.
• This product may only be used by one child at the same time
• The parking device shall be engaged when placing and removing the children
• The maximum basket load is 2 kg.
• Do not hang any bags on the parent handle.
• Any additional load suspended from the buggy handles, backrest and sides will cause stability loss.
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
• Lift the front suspension when going up a curb or step.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
• The carrying strap must not be mounted when the child is in the stroller. Children must not have access to the stroller -
danger of suffocation. The carrying strap is used to make it easier to transport the stroller when it is folded.
• Stop using the baby carriage if you have any doubts concerning its usage or suspect any danger.
B. ASSEMBLY
I. BUGGY COMPONENTS (FIG. 1)
A. Frame
B. Leg cover
C. Safety bar
II. UNFOLDING BUGGY FRAME Place the frame (A) on a flat surface. Start unfolding the Baby stroller by pressing the parents'
handle against the Baby stroller frame so that all the elements are tightly connected. In order to unfold the frame, slide the
lock located on the parent handle, then press the button (FIG.2A) and lift the frame upwards following the arrow in Figure
2B until you hear the locking sound.
III. ASSEMBLY/DISASSEMBLY OF SAFETY BAR, COVER, RAIN COVER, CANOPY ADJUSTMENT The safety bar should be
inserted into an appropriate opening in the seat as shown in figure 3. To disassemble, press the button and remove the
safety bar (FIG. 4). Push the leg cover over the stroller and fasten it with clips located on the frame of the stroller. To adjust
and unfold another layer of material of canopy, unfasten the zip located on the canopy. It is possible to fasten a cover on
the backrest of the stroller. To do this, attach the loops to the canopy (FIG.20).
IV. USE OF BRAKE The buggy is equipped with a foot brake located on the rear axle. Press the lower part of the brake down;
the brake is activated when you hear the locking sound (FIG. 5A). Unlocking occurs after lifting the lower part of brake lever
(FIG. 5B).
V. LOCK OF FRONT WHEEL The front wheels can be locked for straight ahead driving. This function is activated by moving
the slider as shown in Fig. 6. To unlock the front wheels, move the slider to its initial position. Caution! To fold the stroller,
unlock the front wheels.
VI. BACK AND FOOTREST ADJUSTMENT AND CUP HOLDER ASSEMBLY The seat is equipped with smooth backrest
adjustment system, from a lying to a sitting position, using a clasp (Fig.7). The footrest has 3 positions. Pull the lever on the
D. Cup holder
E. Rain cover
F. Carrying strap
21