Grounding Instructions - Kobalt K7343 Mode D'emploi

GROUNDING INSTRUCTIONS

In the event of a malfunction or breakdown, grounding
•
provides a path of least resistance for electric
current to reduce the risk of electric shock. This
tool is equipped with an electrical cord that has an
equipment-grounding conductor and a grounding plug.
The plug must be plugged into a matching outlet that
is properly installed and grounded in accordance with
all local codes and ordinances.
Do not modify the plug provided. If it will not fit into the
•
outlet, have the proper outlet installed by a qualified
electrician.
Improper connection of the equipment-grounding
•
conductor can result in a risk of electric shock.
The conductor with insulation that has an outer
surface that is green with or without yellow stripes
is the equipment-grounding conductor. If repair or
replacement is necessary, do not connect the equipment-grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not
•
completely understood, or if in doubt as to whether the tool is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles that
•
accept the tool's plug.
Repair or replace damaged or worn cord immediately.
•
This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in
•
sketch A in the figure above. The tool has a grounding plug that looks like the plug illustrated
in sketch A in the figure above. A temporary adapter, which looks like the adapter illustrated in
sketches B and C, may be used to connect this plug to a 2-pole receptacle as shown in sketch
B if a properly grounded outlet is not installed by a qualified electrician. The green-colored rigid
ear, lug, and the like, extending from the adapter must be connected to a permanent ground,
such as a properly grounded outlet box.
SPECIFIC SAFETY WARNINGS FOR THE ROUTER TABLE
WARNING: For your own safety, read owner's manual before using Router or Router Table.
Always wear eye protection.
•
Feed workpiece against router bit rotation.
•
Do not use awkward hand positions.
•
Keep fingers away from revolving cutter. Use fixtures when necessary.
•
Use overhead guard when adjustable fence is not in place.
•
Do not expose to rain or use in damp location.
•
Risk of fire or electric shock. Total circuit load for the two outlets must not exceed 15A.
•
Risk of fire or injury.
•
GROUNDING
PIN
8
METAL
SCREW
A.
B.
COVER OF GROUNDED
.
C
OUTLET BOX
GROUNDED MEANS
kobalttools.com