Kobalt K7343 Mode D'emploi page 5

Do not overreach. Keep proper footing and balance at all times. This enables better control
•
of the power tool in unexpected situations.
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
•
gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving
parts.
If devices are provided for the connection of dust extraction and collection facilities,
•
ensure these are connected and properly used. Use of dust devices can reduce dust-related
hazards.
POWER TOOL USE AND CARE
Do not force the power tool. Use the correct power tool for your application. The correct
•
power tool will do the job better and safer at the rate for which it was designed.
Do not use the power tool if the switch does not turn it on and off. Any power tool that
•
cannot be controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source and/or the battery pack from the power
•
tool before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
Store idle power tools out of the reach of children and do not allow persons unfamiliar
•
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for mislignment or binding of moving parts, breakage of
•
parts and any other condition that may affect the power tool operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained power
tools
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
•
edges are less likely to bind and are easier to control;
Use the power tool, accessories and tool bits etc. in accordance with these instructions,
•
taking into account the working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a hazardous situation.
SERVICE
Have your power tool serviced by a qualified repair person using only identical
•
replacement parts. This will ensure that the safety of the power tool is maintained.
SPECIFIC SAFETY WARNINGS FOR ELECTRIC ROUTER
Hold a power tool by insulated gripping surfaces, because the cutter may contact its own
•
cord. Cutting a "live" wire may make exposed metal parts of the power tool "live" and shock the
operator.
Use clamps or another practical way to secure and support the workpiece to a stable
•
platform. Holding the work by your hand or against the body leaves it unstable and may lead
to loss of control.
Only use router bits suitable for the no-load speed of the tool.
•
Never use router bits with a diameter exceeding the maximum diameter specified in the
•
technical data section.
Do not use the tool in an inverted position unless it is properly and securely installed to
•
a router table.
Wear a dust mask specifically designed for protection against lead paint dust and fumes
•
and ensure that persons within or entering the work area are also protected.
5
kobalttools.com