Kobalt K7343 Mode D'emploi page 25

23. INSTALLING TABLETOP INSERTS
This router table includes three tabletop inserts, each
with openings of different diameters: insert with 1-1/4
diameter hole, insert with 1-7/8
insert with 2-1/8 diameter hole.
in.
When smaller diameter router bits are used, use the
insert rings to provide additional support to the workpiece
as it nears the bit and to minimize the amount of debris
that falls through the throat opening.
a. If the router is attached to the table, turn it off with the
integrated safety switch (V).
b. Position the tabletop insert over the insert opening in
the router table.
c. Press down evenly over the tabs until the insert locks
in place.
d. To remove, pull up gently until the tabs disengage.
e. When not in use, store tabletop inserts in a convenient place.
WARNING: DO NOT attempt to remove tabletop inserts from the insert opening until the router
is turned off and the router bit comes to a complete stop.
WARNING: DO NOT use bits that have a cutting diameter that exceeds the clearance hole
in the table inserts. Select a table insert that has a clearance hole that is 3/4 in. larger than the
diameter of the cutter bit being used.
24. ATTACHING THE FENCE ASSEMBLY TO THE TABLE
WARNING: Always unplug the router before attaching or removing the fence.
a. The fence is shipped completely assembled; loosen
the two bolts and clamping knobs before attaching it
to the table.
b. Place the fence assembly on the tabletop surface
and align the two holes on the bottom of the fence
assembly with the two slots on the router table.
c. From underneath, slide the two long round-head
square-neck bolts through the left hole and the right
hole respectively. Slide a plain washer onto each bolt.
Secure the fence to the tabletop surface by tightening
the clamping knobs.
d. To prepare the table for transportation and storage,
loosen the clamping knobs, push the fence back and
remove the fence from the table.
WARNING: Always attach the fence to the table when you use the router table.
diameter hole, and an
in.
25
23
in.
V
24
kobalttools.com