Kobalt K7343 Mode D'emploi page 24

22. ATTACHING THE FIXED ROUTER TO THE TABLE
a. Unplug the router and the router table.
b. Remove the plastic sub-base (F)
from the fixed base (D).
c. Remove the screws that secure the universal router
mounting plate (D1) and remove it from
the router table.
d. Place the router upside down so that it is resting on its
top cap and align the three holes (a) in the center of
the universal router mounting plate with the holes in
the router. Make sure that the hole is aligned
with the table-above depth adjustment nut
located on the router.
e. Insert a flat-head screw through each of the three
holes in the universal router mounting plate and into
the holes in the router base, and then tighten each
flat-head screw securely.
f. Re-install the universal router mounting plate to the
router table and replace and loosely tighten the 4
screws that were removed in step 3.
g. Install the four leveling screws into the four holes
around the universal mounting plate opening. Adjust
the mounting plate height so that it is flush with the
table. A turn to the right raises the universal mounting
plate and a turn to the left lowers the plate.
h. Using a straight edge (available separately), check
to be certain that the surface of the universal router
mounting plate is flush with the tabletop surface.
i. To hold the mounting plate in position, tighten the
four screws in Step 3. Recheck to make sure that the
surface of the router mounting plate is flush with the
tabletop surface. If not, repeat Step 6.
NOTICE: Failure to make sure that the universal router
mounting plate is flush with the tabletop surface can
result in poor routing performance. Slide a square-
cut board from right to left across the universal router
mounting plate to be sure that the board moves smoothly.
22a
22b
22c
22d
24
F
D
kobalttools.com