Troubleshooting; Warranty - Kobalt K7343 Mode D'emploi

TROUBLE SHOOTING
PROBLEM
The router does not work
The table surface
is not flat
The router cannot be
attached to the table

WARRANTY

The manufacturer warrants to the original purchaser that each new product is free from defects in material and
workmanship and agrees to replace under this warranty any defective product as follows from the original date of
purchase.
Three (3) Year Limited Warranty.
•
THIS WARRANTY IS NOT TRANSFERABLE AND DOES NOT COVER:
•
Products sold damaged or incomplete, sold "as is," sold reconditioned or used as rental equipment.
•
Products that have ever been used while providing commercial services or have been rented to another
•
person.
Delivery, installation or normal adjustments explained in the owner's manual.
•
Damage or liability caused by shipping, improper handling, improper installation, incorrect voltage or improper
•
wiring, improper maintenance, improper modification, or the use of accessories and/or attachments not
specifically recommended.
Repairs necessary because of operator abuse or negligence, or the failure to install, operate, maintain and
•
store the product according to the instructions in the owner's manual.
Damage caused by cold, heat, rain, excessive humidity, corrosive environments and materials, or other
•
contaminants.
Expendable items that become worn during normal use.
•
Cosmetic defects that do not interfere with tool functionality.
•
Freight costs from customer to vendor.
•
POSSIBLE CAUSE
The router is not plugged into
the router table outlet
The power cord for the router
table is not connected to a
power source
The switch on the router table
is in the "OFF" position
The carbon brushes have
worn out
The legs are not properly
assembled
The work surface is not flat
The sub-base is still on the
router base
33
CORRECT ACTION
Plug the power cord from
the router into the router
table outlet
Plug the power cord for the
router table into a power
source
Insert the key and pull the
switch to the "ON" position
Remove the carbon brush
caps and replace the old
brushes with the new ones
Check assembly directions
and tighten all fasteners
securely
Place the router table on a
flat, level surface
Remove the plastic sub-
base from the router base
KOBALT and the K Design are registered trademarks
® ®
of LF, LLC. All Rights Reserved.
kobalttools.com
Printed in China