Kobalt K7343 Mode D'emploi page 13

WARNING: The safe use of this product requires an
understanding of the information on the tool and in this
operator's manual, as well as knowledge of the project
you are attempting. Before attempting to use any tool, be
sure to become familiar with all of the operating features
and safety rules. Do not allow familiarity with the tool
to cause carelessness. Remember that one careless
moment is enough to cause severe injury.
1. LED worklights
The router motor has 3 built-in worklights, located around
the collet; these provide high visibility of the workpiece
when cutting. These lights are always "on" when the
toggle switch is in the "ON" position.
2. "Live-tool indicator" light
The live-tool indicator light (A) is located on the motor
housing top cap where the power cord enters the motor
housing. This green light is always on when the router
motor is plugged into a power source.
3. Heavy-duty edge guide
The edge guide (T) can be used as an aid in routing
applications such as decorative edging, straight-edge
planing and trimming, grooving, dadoing, and slotting.
To assemble the edge guide onto fixed base, simply
insert the edge-guide rods into the edge-guide mounting
slots (R), adjust to the desired position, and lock them in
place with the edge-guide locking knobs (S).
4. Dust collection with a vacuum adaptor
The vacuum adaptor (A1) is sized to accept
a 1-1/4 (3.2 cm) vacuum hose adaptor (not included).
in.
To attach the adaptor onto the fixed base (D),
position and secure it to the back of the base using the
two screws (included).
5. Chip Guard
WARNING: The chip guard helps keep dust and chips
away from the operator. It will not stop objects larger than
woodchips that are from the bit. The chip guard is not
intended as a safety guard. ALWAYS wear eye protection.
CAUTION: ALWAYS have the chip guard in place on
the base when operating the router.
To remove the chip guard (I) from the fixed base (D),
press inward on its tabs until the chip guard releases from
the fixed base, and then remove it. To attach the chip
guard, place it back in position, and flex the sides while
pushing it in until it snaps back into place.
1
2
3
4
5
13
S
D
Tabs
kobalttools.com
A
T
D
A1