Kobalt K7343 Mode D'emploi page 26

25. ATTACHING THE MITER GAUGE
a. Attach the miter gauge (B1) to the table by placing the
miter-gauge bar in the slot on the table.
b. To adjust the miter gauge, loosen the miter gauge
knob, rotate the miter gauge to the desired angle and
tighten the knob again.
26. ATTACHING THE FEATHER BOARDS
WARNING: Always unplug the router before you use
the router table.
NOTICE: The front and back side of each feather board is
marked to indicate proper feed direction.
Attach the feather board to the fence
a. Place the feather board (Y) on the fence assembly as
shown.
b. Insert two long, round-head square-neck bolts through
the two holes in the fence and the slots in the feather
board.
c. Place a plain washer onto each bolt, then thread the
wing nuts onto the bolts and tighten them to secure
the fence and feather board.
Attach the feather board to the tabletop surface
a. Place the feather board (Y) on the tabletop surface.
b. Place an ellipse-shaped washer onto each long
round-head square-neck bolt, then insert the bolts
through the holes in the tabletop surface and the slots in the feather board.
c. Place a plain washer onto each bolt, then thread the wing nuts onto the bolts and tighten them
to secure the fence and feather board.
27. ATTACHING THE TABLE TO A WORK SURFACE
a. Place the router table upright on a sturdy surface,
such as a work stand, workbench, or countertop.
b. While holding the router table in place, mark the
location of the two mounting holes (11/32
in each of the legs on the work surface.
c. Remove the router table.
d. Drill a hole into the work surface at each of the
marked locations.
e. Place the router table on the work surface and align
the holes in the table legs with the holes in the work
surface.
f. Secure the router table to the work surface with four
bolts and nuts (not included).
g. Tighten the bolts securely.
25
26
27
diameter)
in.
26
Y
Y
kobalttools.com
B1