Electrical Connections - CAME ZL170N Mode D'emploi

Electrical connections

Power supply for control unit 230V (a.c.)
L1-L2
Power supply to accessories (max. 40W):
10-11
- 24V (a.c.) with power supply at 230V (a.c.)
- 24V (d.c.) with power supply at 24V (d.c.)
24V-3W max. gate-open signal lamp
10-5
24V-25W max. output in motion (e.g. flashing light)
11-S
Connection for electrically-actuated lock: 12V-15W max.
10-E
Control panel/gear motor connections ( ADT card )
M-N-R
Transformer Heat Overload trip contact
T-T
10-E3
- A (default)
JUMPER IN POSITION
24V - 25W max cycle indicador
light
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
1-2
2-3
2-7
2-C1
2-C3
A1-A2
a
A
Jumper J2
Stop button (N.C.)
Open button (N.O.)
Connector (N.O.) radio and/or pushbutton
Contact (N.C.) for re-opening during closure
(should be short circuited if not used)
Partial stop contact (N.C.)
Contact outlet (N.O.): it is closed for 3" upon opening command.
Contact capacity: 5A (250V AC)
Antenna connection - cable RG58
B
-
JUMPER IN POSITION
B1-B2
B
Contact output (N.O.) 2 nd radio
channel
Contact capacity: 1A to 24V d.c.
9