CAME ZL170N Mode D'emploi page 12

Adjusting the stop zone
Prepare a 60x30 mm template and hold it up against one of the two mechanical stops as shown in fi g. 1 (adjustment is to be made either on the closing
endstop or opening endstop).
Activate the gate - either using a command button or the remote control - and turn the OP TIME (T.L.) trimmer clockwise until the gate leaf inverts its direction
just as it touches the obstacle/template.
Then turn the template from its short side (fi g. 2) and turn the OP TIME (T.L.) trimmer counterclockwise until the gate leaf stops against the obstable/tem-
plate.
Fig.1
Fig.3
12
OP TIME
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
Fig.2
A = Amperometric sensor's operating area with
inverted movement
B = Normal speed operating area
C = Slowdown speed operating area
D = Amperometric sensor's operating area with
stopped movement
E = Closing and opening endstops
OP TIME