Replacing Carbon Brushes; Accessories - Makita SA9031 Manuel D'instruction

Operation with wire wheel brush (optional
accessory)
CAUTION:
Check operation of wire wheel brush by running
•
tool with no load, insuring that no one is in front of
or in line with the wire wheel brush.
Do not use wire wheel brush that is damaged, or
•
which is out of balance. Use of damaged wire
wheel brush could increase potential for injury from
contact with broken wires.
ALWAYS use guard with wire wheel brushes,
•
assuring diameter of wheel fits inside guard. Wheel
can shatter during use and guard helps to reduce
chances of personal injury.
1
010789
Unplug tool and place it upside down allowing easy
access to spindle. Remove any accessories on spindle.
Thread wire wheel brush onto spindle and tighten with
the wrenches.
When using wire wheel brush, avoid applying too much
pressure which causes over bending of wires, leading to
premature breakage.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
The tool and its air vents have to be kept clean. Regularly
clean the tool's air vents or whenever the vents start to
become obstructed.
1
011643
1. Wire wheel
brush
1. Exhaust vent
2. Inhalation vent
2

Replacing carbon brushes

1
001146
When the resin insulating tip inside the carbon brush is
exposed to contact the commutator, it will automatically
shut off the motor. When this occurs, both carbon
brushes should be replaced. Keep the carbon brushes
clean and free to slip in the holders. Both carbon brushes
should be replaced at the same time. Use only identical
carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
010347
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you decide to use your Makita sander with
•
approved accessories which you purchase from
your Makita distributor or factory service center, be
sure to obtain and use all necessary fasteners and
guards as recommended in this manual. Your
failure to do so could result in personal injury to you
and others.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
8
1. Commutator
2. Insulating tip
2
3. Carbon brush
3
1. Brush holder cap
2. Screwdriver
or attachments
Only use accessory or
are