Troubleshooting Table - THERMOBILE TBD 18 Manuel De L'utilisateur

6.1 Trouble shooting table
Fault
The heater is not 1 The heater has no voltage.
functioning.
2 Defect in the operating panel.
3 Phase - exchange the ZERO wires in a 5-
4 Internal fuse (2A) faulty. (VTB
The fan does not turn 5 The thermostat is set to a too low
and there is no heat.
6 Fuse is faulty in your sys- tem.
7 Fan motor is broken.
The fan does not turn 8 Fuse is faulty in your sys- tem.
but the heater does
heat up.
9 Fan faulty
The fan does turn but 10 Voltage too low
the heater does not
emit heat.
11 One fuse is faulty in your system.
12 Cable of the extension cable faulty. Heater
The fan turns as nor- 13 One fuse is faulty in your system.
mal but there is little
heat, 50%.
14 Cable of the extension cable faulty.
15 Heater functions on 2 phases.
16 One loose or burnt cable in the
TBD 18
THERMOBILE INDUSTRIES BV
Cause
pole connector/ female connector.
9000/15000)
temperature.
functions on 2 phases.
connector/female connector or extension
cable.
Solution
Check the electrical con- nection.
Repair or replace the operating
panel.
Repair the connection.
Replace the fuse.
Correct the settings.
Replace the fuse. (Make sure it is
tight.)
Replace the fan motor.
Replace the fuse. (Make sure it is
tight.)
Replace the fan motor.
Check the electrical con- nections. Dealer
Replace the fuse. (Make sure it is
tight.)
Repair the connection of the
system.
Replace the fuse. (Make sure it is
tight.)
Repair the connection.
Repair the connection.
Repair the connection.
Action
User
Dealer
User
Dealer
User
User
Dealer
User
Dealer
User
User
User
User
User
User
15