Maintenance Instruc-Tion - PLYMOVENT JUNIOR LM-2 Manuel Opérateur

JunIor
LM-2
A. If the arm will not stay in the required position:
1. Loosen the hose at A.
2. Pull the extractor out to its full length and angle it horizontally. Loosen the friction
3. If the arm is difficult to move sideways or moves on its own sideways, then adjust-
B. If the hood will not stay in the required position:
1. Loosen the hose at B.
2. Adjust the friction (see picture) until the hood will stay in the exact position.
C. If it is difficult to extend and contract the arm:
1. Check that the telescopic tube is not damaged or dirty. If it is damaged, replace it.
2. Check the counterweight wire. If it is damaged replace it, as per the following
0000101027/071013/A Junior LM-2
brake until the arm drops towards the floor. Tighten until it no longer drops.
ments must be made to the friction collar. This is done by either loosening
or tightening the screw. Use an allen key.
If it is dirty, brush it down with a wire brush or abrasive cloth and then wipe
it clean with a cloth.
intructions and diagrams overleaf.
MaInTenance InSTruc-
TIon
© Copyright 2008: All rights reserved. All information within this printed matter may not be reproduced,
handed over, copied, xeroxed or translated into another language in any form or means without written
permission from Plymovent AB. Plymovent AB reserves the right to make design changes.
BSAB no: T0.31
Ser.no: LM/DS
Date: Sept-97
Replace: Jan-95
EN - 7
LM/10/13