Stand; Playing Ipod/Iphone/Ipad - Pioneer X-CM32BT-K Mode D'emploi

iPod/iPhone/iPad playback
2 Set up to stand the iPod/iPhone/iPad.
When using an iPod/iPhone
Make sure the iPod/iPhone cable is aligned along the groove
for it on the back of the stand that comes with the unit.
When using iPad
Make sure to place the iPad in a horizontal direction on the

stand.

Playing iPod/iPhone/iPad

1 Connect your iPod/iPhone/iPad.
If an iPod/iPhone/iPad is connected when this unit is on,
playback of the iPod/iPhone/iPad will not begin.
2 Press USB as the input source.
"USB/IPOD" is shown on the main display.
3 When the recognition is completed, will
begin playing automatically.
CAUTION
• When your iPod/iPhone/iPad is placed on the stand and
you wish to operate the iPod/iPhone/iPad directly, be
sure to steady the iPod/iPhone/iPad with the other hand
to prevent malfunctions due to faulty contacts.
Back of stand
iPod/iPhone
cable
Note
• iPod/iPhone/iPad recharging occurs whenever an iPod/
iPhone/iPad is connected to this unit. (This function is
supported in standby mode as well.)
• When input is switched from USB to another function,
iPod/iPhone/iPad playback is temporarily stopped.
• When iPod/iPhone/iPad is not playing and no operations
have been performed for more than 20 minutes, the unit
will automatically power off. In this case it is required
that the Auto power off is switched to ON.
• Auto power off can be switched to ON/OFF (page 36).
Important
• If this unit cannot play your iPod/iPhone/iPad, perform
the following troubleshooting checks:
- Check whether the iPod/iPhone/iPad is supported by
this unit.
- Reconnect the iPod/iPhone/iPad to the unit. If this
doesn't seem to work, try resetting your iPod/iPhone/
iPad.
- Check the iPod/iPhone/iPad software is supported by
this unit.
• If the iPod/iPhone/iPad cannot be operated, check the
following items:
- Is the iPod/iPhone/iPad connected correctly?
Reconnect the iPod/iPhone/iPad to the unit.
- Is the iPod/iPhone/iPad experiencing a hangup? Try
resetting the iPod/iPhone/iPad, and reconnect it to the
unit.
05
19
En