Maintenance And Cleaning - Vicair AllRounder O2 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
To remove and replace the Harness base,
perform the following steps. These instructions
correspond to image i (I, II & III) on the quick
installation guide.
Completely open the zipper following the
bottom of the cushion to detach the Harness
base from the cushion.
To adjust the filling grade, now open the
cushion's zipper. Add or remove the desired
number of SmartCells from one or more
compartments and close the zipper. Make
sure that you do not damage the SmartCells.
Attach the cushion to the (replacement)
Harness base by using the zipper following
the bottom of the cushion. Make sure that
you do not damage the cushion.
Disposal
The disposal and recycling of used devices and
packaging must comply with the applicable legal
regulation. Ensure the product is cleaned prior
to disposal to avoid any risk of contamination.

MAINTENANCE AND CLEANING

Warning! Every three months, check the product
for wear and deflated cells. In case of serious
damage, or a large number of deflated cells, do
not continue to use the product. Consult your
dealer.
Caution! Do not steam clean or autoclave the
product. The product cannot withstand
excessive heat or pressure. When the given
cleaning instructions are not followed, it is very
likely that the product will age more rapid.
Caution! Do not use aggressive or abrasive
cleaners, or sharp objects to clean the cushion.
Caution! Do not place the topside of the Vicair
O2 cushion against the glass of the washer door.
Cleaning the Vicair AllRounder O2
Your Vicair AllRounder O2 can be machine
washed at 60°C / 140 °F using an anti-crease
cycle and mild detergent. Close the waist strap
and leg straps before washing. You do not need
to remove the SmartCells or the Harness base
before putting the Vicair AllRounder O2 in the
washing machine. Make sure the topside of the
cushion is not placed against the glass of the
washer door. Do not load the machine with
more than half of its maximum load weight.
Spin speed should be reduced. When using a
machine with agitator, make sure that the
cushion can move freely within the drum. Do not
use any chlorine bleach and do not dry clean!
Do not tumble dry your Vicair AllRounder O2,
but let it air dry.
0 2 3 7 9
Disinfecting your Vicair AllRounder O2
Warning! In case of soiling with body fluids, and
when transferring the product to another user,
the product must be disinfected to avoid cross
contamination. Clean the Vicair AllRounder O2
as instructed above. Preferably use an anti-
bacterial detergent. After cleaning spray the
Vicair AllRounder O2 with a disinfectant. Bend
compartments outwards to make sure the spray
gets into the gaps.
E N
7

Publicité

Table des Matières
loading

Table des Matières