Publicité
Les langues disponibles
Les langues disponibles
Volvo S60
2001 - ....
Ref. 1284
Fitting instructions
1)
Disassemble the bumper. Permanently remove the towing ring on the right side of the vehicle. Loosen
the exhaust in the rear and permanently remove the exhaust support.
2)
Place the towbar with points (A) on the screw-thread holes which were liberated by removing the exhaust
support and the towing ring. Insert the bolts and washers and tighten firmly.
3)
Make an incision in the bumper (see drawing) of 50mm wide and 60mm measured as from the lower rim
of the bumper (certainly beyond the field of vision).
4)
Replace the bumper and fix the exhaust on the exhaust support which is provided on the towbar.
5)
Assemble the ball (*) and tighten firmly.
Composition
1 towbar reference 1284
1 ball T45M022
2 mounting pieces T45
2 tubes T45
2 bolts M12x60 - DIN931
2 bolts M12x65 - DIN931
4 security nuts M12 - DIN985
6 bolts M12x35 - DIN933
6 washers 13x24x2,5
2 cross recessed mushroom head screws (4,8x19)
2 speed-nuts
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*-*')
(*')
(*)
(*')
(*-*')
(A)
(A)
Publicité
