Operating instructiOns
Operating instructiOns
OVERVIEW
This is a high performance battery charger that has the ability
to properly and safely work with LEAD-ACID: FLOODED/
WET CELL, MAINTENANCE FREE, and AGM/STARVED
ELECTROLYTE batteries only. It is important to read and
understand how to properly use the battery charger before
charging batteries.
GENERAL OPERATION
After the AC cord on the charger is plugged in and a battery is connected to the output cable correctly, the Yellow LED will turn
on. After 4 seconds the charger will begin charging the battery. The 4 second delay is added to allow the user to establish a
good connection before the charger output is turned on. This will help prevent unwanted sparks during battery connections.
INDICATOR LEDS
Each bank has the following LEDs:
•
A solid RED LED indicates there is an issue with the
battery connection.
•
A flashing RED LED indicates an error. See the
Troubleshooting section of this manual.
•
A YELLOW LED indicates the progress of charging.
•
A flashing GREEN LED indicates battery is fully charged, in
Maintenance Mode and ready to use.
•
A solid GREEN LED indicates battery is fully charged, in
long term Maintenance Mode and ready to use.
NOTE:
If a RED LED is on, reference the Troubleshooting Section of this manual to determine the reason and take the
necessary corrective action to remedy the situation. If you are unable to remedy the situation and need help, call the
Minn Kota Service Department at 1.800.227.6433 and a technical support representative will be happy to assist you.
©2017 Johnson Outdoors Marine Electronics, Inc.
Single Bank
Battery Charger
Black-
12v Battery
120V AC Input
Red+
minnkotamotors.com | 11