Cutting Speed Adjustment (Fig. 8B); Adjusting The Feed Speed For The Autonomous Cutting Version (Fig. 11); Correct Positioning Of The Workpiece In The Clamp; Installation And Adjustment Of Bandsaw Bar Holder (Optional Fig. 6A - 6B) - Femi 785XL Instructions Pour L'utilisation Et L'installation

3.5. CUTTING SPEED ADJUSTMENT (Fig. 8B)

NOTES
Adjust the cutting speed as indicated in this manual. The device for regulating speed
depends on the specifi c machine model.
Select the speed (from 35 to 80 m/min) using the speed regulator (29).
3.6. ADJUSTING THE FEED SPEED FOR THE AUTONOMOUS CUTTING VERSION
(Fig. 11)
a) Lift the arm to its maximum height.
b) Press the catch (17) to release the selector switch.
c) Position the selector (16) on the required feed speed (H, M, L, LL)
d) Release the catch (17).
3.7. CORRECT POSITIONING OF THE
WORKPIECE IN THE CLAMP
Position the workpiece to be cut directly
between the jaws, without placing any other
objects between the workpiece and the jaws.
DANGER - WARNING
TO POSITION FLAT OR SPECIAL
SHAPED PROFILES, PLEASE REFER
TO THE EXAMPLES PROVIDED IN
THE FIGURES.
IF THE THICKNESS OF THE PROFILE IS VERY THIN, TO STOP IT FROM GETTING
CRUSHED IN THE JAWS OF THE CLAMP, PUSH
A MOULD INTO THE PROFILE WHICH MATCHES ITS SHAPE
3.8. INSTALLATION AND ADJUSTMENT OF BANDSAW BAR HOLDER (OPTIONAL
Fig. 6A - 6B)
a) Install the guide rod (22) in the hole on the base.
b) Tighten nut (23).
c) Slacken the handwheel (24) and position the holder (10) at the required distance.
d) Tighten the handwheel (24).
Art. NG160, ABS NG160 - 1750XL
EN
31