Makita LXLC01 Manuel D'instruction page 9

008934
Wash the dust bag in soapy water when it is clogged with
dust and the cleaner power becomes small. Dry it out
thoroughly before use. An insufficiently dried bag may
cause poor suction and shorten the service life of the
motor.
NOTE:
Dust pack is a throw-away type.
•
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Removing and installing the sponge filter
1
011557
To remove the sponge filter, remove the dust bag or dust
pack and then pinch and take it out.
1
011556
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/dust pack mounting
area.
CAUTION:
After cleaning sponge filter, be sure to install it on
•
the cleaner. If washed in water, dry it up before
installing. An insufficiently dried sponge filter may
shorten the service life of the motor.
1. Sponge filter
1. Recessed wall
9