Cleaning From Below - Wohler Snap & Sweep Mode D'emploi

Assembly and disassembly of the system
6.4

Cleaning from below

30
Place a soot bag under the chimney opening.
•
Install the cleaning tool on a rod.
•
Slide the rod with the cleaning tool into the
•
chimney.
NOTE!
If necessary, you can seal the chimney opening
with a soot protection cone or a sealing element
and pass the rod through a hole in the element.
Connect a second rod to the first.
•
Connect the drill to the lower end of the rod.
•
Switch on the drill to rotate the cleaning at-
•
tachment and push the rod as far as possible
into the chimney at the same time.
NOTE!
Dieser Schritt gilt nicht für das System Snap &
Sweep Strong. Hier nur stoßend arbeiten!
Separate the drill from the rod and connect it
•
to the next rod.
Repeat the process until the entire chimney
•
has been cleaned.
When pulling out the rods, work in reverse or-
•
der.
NOTE!
It is recommended to spread the bag as a base.
Rods and cleaning tools can be placed there after
use. This prevents a pollution of the working area.