Working With The Wöhler Snap & Sweep-System; Mounting The Adapter And The Rod - Wohler Snap & Sweep Mode D'emploi

Working with the Wöhler Snap & Sweep-System
5 Working with the Wöhler Snap & Sweep-System
5.1 Mounting the Adapter
and the rod
Fig. 11: Cordless angle drill with drill
adapter
28
2
1
The Wöhler Snap and Sweep System is rotated
by a cordless screwdriver or a drill. This does not
apply to the "Snap & Sweep Strong" system.
NOTE!
When cleaning very big chimneys with the red
rods we recommend not to rotate the rods by a
screwdriver or drill. Only push the rods.
NOTE!
For safe handling, the use of an angle battery
screwdriver is recommended.
WARNING!
Before mounting the adapter, cleaning tools and
rods, always block the operating switch of the
cordless screwdriver to prevent unintentional
starting!
• Unscrew the drill chuck (1) counterclockwise.
• Insert the adapter (2) into the drill chuck.
Tighten the drill chuck (1) clockwise.
•
Slide the male rod connector into the adapter.
•
The tabs of the connector must be inserted in-
to the holes of the adapter until they snap into
place.
WARNING!
The tabs of the plug must be inserted into the re-
cesses of the drill until they click into place!