Proper Use; Address - Wohler Snap & Sweep Mode D'emploi

1.3

Proper use

1.4

Address

The Wöhler Snap and Sweep System is used for
cleaning chimneys, exhaust pipes and air ducts.
Cleaning can be carried out by one person.
For this purpose, a cleaning attachment is placed
on a rod. The rod is then extended by any number
of additional rods.
For cleaning, the rods can be pushed by hand or
rotated with a cordless screwdriver or a drill. Do
not use the Wöhler Hammer Probe for any other
use than set out in this manual.
ATTENTION!
The Wöhler Snap & Sweep System can be used
for cleaning pipes with a diameter of Ø 15 cm or
more.
ATTENTION!
The Wöhler Snap & Sweep Strong System can-
not be used in rotation. The rods must be pushed.
Wöhler Technik GmbH
Wöhler-Platz 1
33181 Bad Wünnenberg
Tel.: +49 2953 73-100
Fax: +49 2953 73-250
E-Mail: info@woehler.de
General Information
EN
21