Disconnecting; Cleaning From Below - Wohler 24471 Mode D'emploi

Assembly and disassembly of the system
6.3

Disconnecting

6.4

Cleaning from below

26
Press the snap straps inwards with the fingers
•
and thumb of your left hand and simultaneous-
ly pull the rod or cleaning tool out of the fe-
male connector with your right hand.
Place a soot bag under the chimney opening.
•
• Install the cleaning tool on a rod.
• Slide the rod with the cleaning tool into the
chimney.
NOTE!
If necessary, you can seal the chimney opening
with a sealing element and pass the rod through a
hole in the element.
Connect a second rod to the first.
•
Connect the drill to the lower end of the rod.
•
Switch on the drill to rotate the cleaning at-
•
tachment and push the rod as far as possible
into the chimney at the same time.
• Separate the drill from the rod and connect it
to the next rod.
Repeat the process until the entire chimney
•
has been cleaned.
When pulling out the rods, work in reverse
•
order.
NOTE!
It is recommended to spread the bag as a base.
Rods and cleaning tools can be placed there after
use. This prevents a pollution of the working area.