BEA LZR-MICROSCAN T Mode D'emploi page 7

INSTALLATION (cont.)
Eagle (optional)
1
Install Eagle(s). For complete
installation instructions refer to
BEA User's Guide 75.5601.
Push Plates (optional)
Multiple push plates can be paralleled to gray wires of System Harness.
1
Install push plate(s). For complete
installation instructions refer to
the appropriate BEA User's Guide.
Door Control Harness
If door system utilizes independent door controls, repeat steps 1 – 2 for the second control.
1
Plug Door Control Harness into
hub port labeled Door Control A.
75.5753.14 LZR-MICROSCAN T 20180208 75.5753.14 LZR-MICROSCAN T 20180208
2
Plug Eagle Harness(es) into hub
port labeled Motion 1 and, if
applicable, Motion 2.
2
COM
NO
Wire-nut push plate wires or
wireless receiver (COM and NO)
to gray wires of System Harness
plugged into hub.
2
Wire Door Control Harness to
door control.
All white wires (white, white/black, white/red)
are always used.
For each function (activation, safety, stall), either
green or yellow are used - not both.
See Tech Bulletin #53 for more information.
For dual-egress doors with independent
stall, two (2) Door Control Harnesses
must be used.
GREEN
YELLOW
WHITE
GREEN/BLACK
YELLOW/BLACK
WHITE/BLACK
GREEN/RED
YELLOW/RED
WHITE/RED
ACT N.O.
ACT N.C.
ACT COM.
SAFE N.O.
SAFE N.C.
SAFE COM.
STALL N.O.
STALL N.C.
STALL COM.
Page 7 of 16 Page 7 of 16