Push Automatic Opening Function - Pando PVMAV 45-18 Manuel D'utilisation Et Installation

INOXPAN S.L.

5.2. PUSH AUTOMATIC OPENING FUNCTION

Only for models:
The PUSH function of opening and closing the door is activated when the unit is switched on. To
open the door, press firmly on the upper front centre and release again. The door will open
approx. 2 ~ 7 cm. by the push piston housed in the frame. Then the door can be opened
completely manually.
NOTE: Do not block the door or hold it while it is opening. If the door is locked or held during
opening, the door opening mechanism - push piston - and the door will be damaged, potentially
causing serious damage not covered by the warranty.
Do not push the opening piston or hold it during closing. If the piston is blocked during closing or
is inserted inside its base, it can no longer reach its initial position.
In the initial position, the opening piston is aligned with the front of the control panel. To return
the opening piston to its initial position, disconnect the appliance from the mains, wait approx. 10
seconds and plug it back. The piston will return to its initial position.
The door on the unit is sensitive to pressure. The pressure to open the door is possible to
adjust as following steps:
 Open the door.
 Rotate the screw on the top middle of door counterclockwise to increase the sensitivity and
clockwise to decrease the sensitivity.
 Close the door and check if it is correctly adjusted. Rotating the screw counterclockwise too
much can cause the door to open automatically even without pushing. In reverse rotating the
screw clockwise too much can cause the door not to open even with heavy pushing.
 PVMAVP 45-18
 PVMAVP 60-25
 PVMBP 60-45
 PVMAVP 88-49
 PVMAVP 124-70
 PVMAVP 178-112
29
WINE CABINETS