SilverCrest SMZC 500 B2 Mode D'emploi page 28

5) Place the lid
of the bowl
lid .
One of the two catches
should point forwards, towards you.
6) Place the motor unit
catches
on the bottom of the motor unit
into the recesses
a little until it rests flush on the lid
recesses
7) Insert the plug into a mains power socket.
NOTE
► Hold the bowl
hand while processing food.
8) Press the required speed button
you keep the speed button
released.
CAUTION – PROPERTY DAMAGE!
► If the blade
button
the blade
Otherwise, the motor unit could overheat.
NOTE
► If food remains stuck on the inside of the bowl
reach it any more, open the lid
spatula or similar.
9) Once the food is fully chopped, release of the speed button
10) Remove the power plug from the socket.
WARNING – RISK OF INJURY!
► Never attempt to remove food from the bowl
turning. There is a risk of injury and food can also spray out and make a
mess.
11) Wait until the blade
12) Lift the motor unit
SMZC 500 B2
onto the bowl
and the blade holder
that are located on the inner ring of the lid
onto the lid
on the inner ring of the lid
on the bottom of the motor unit
.
firmly with one hand and the motor unit
/
stops and starts or does not turn at all, release of the speed
/ immediately and pull out the mains plug. Check whether
is jammed as a result of too hard/tough food and free this.
has come to a complete standstill.
off the lid
so that the sealing ring
protrudes through the opening of the
so that the logo is facing it. The two
now engage into the two recesses
. If the catches do not slide immediately
, turn the motor unit
and the catches
/ . The blade rotates
pressed. The motor stops as soon as it is
and the blade
and push the food back down with a
while the blade
.
rests on the edge
have slid into the
with the other
as long as
cannot
/ .
is still
GB│IE 25 ■
│