Silverline SILVERSTORM 263570 Mode D'emploi page 8

GB
Troubleshooting
Problem
Machine does not start
No hammering action
The machine does not
operate at full power
Oil is leaking from the
machine housing
8
Possible Cause
Interruption in the power supply
The power cable or mains plug is defective
The on/off trigger switch is defective
Construction site generator in sleep mode
Voltage from generator too low or
incompatible with this machine
The machine is too cold
Insufficient lubrication
A fault has occurred in the machine
The extension lead is too long or of
inadequate cross section
The voltage provided by the power
supply is too low
A fault has occurred in the machine
Seals missing/damaged
Check the power supply; ensure the plug is switched on. Have the power circuit tested
by a qualified electrician
Have the power cable replaced by an authorised Silverline service centre
Have the switch replaced by an authorised Silverline service centre
Activate generator
This machine may be incompatible with this specific power source
Have the machine warm up, then run it under no load to warm up the oil and loosen up
the internal mechanisms
Check oil level (see 'Maintenance') and top up if appropriate. Running the tool with
insufficient lubrication may have caused tool damage, in which case the machine needs
to be repaired by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Use a suitable extension lead
Check power supply and change to a different circuit if possible
Have the tool repaired by an authorised Silverline service centre
If occurring after an oil service or top-up, check the seals underneath the covers that
had been removed during service. Otherwise, have the tool repaired by an authorised
Silverline service centre
Solution