Restoring The Factory Settings - VOX Amplification Dynamic Looper Manuel D'utilisation

VOX Dynamic Looper Owner's manual
5. Use your foot to slowly return the control pedal toward
yourself; when the pedal stops, take your foot off the
pedal.
6. Gently advance the control pedal, and take your foot off
the pedal when it stops.
If you decide to cancel the calibration operation, press the
CANCEL button.
7. Press the WRITE button.
The program/value display will indicate "CPL" for one
second, and then the program number will appear.
If the calibration did not occur correctly, the program/
value display will indicate "Err." In this case, try the
procedure again from step 4.
If you are unable to perform the calibration successfully
after several attempts, it may be that the Dynamic Looper
has malfunctioned. Please contact your nearby VOX
dealer.
40

Restoring the factory settings

Here's how to restore the Dynamic Looper to its factory-set
state.
Note: This operation will initialize any programs that you've
saved, returning all of them to the factory-set programs.
1. Turn the power off.
2. While holding down the CANCEL button and the PRE
FX TARGET button, turn the power on.
3. When the program/value display blinks "Int," release
the buttons.
If you decide not to execute the factory reset, press the
CANCEL button.
4. Press the WRITE button.
When the programs have been initialized successfully, the
program/value display will indicate "CP," and then the
Dynamic Looper will start up in the normal way.
Never turn off the power while initialization is being
executed.