VOX Dynamic Looper Owner's manual
You'll also use this pedal to specify the tempo for the
metronome or for BPM sync-type effects.
This pedal also turns on/off the Loop Quantize function that
adjusts the end of the loop according to the tempo when you
stop recording, allowing you to create loops that are exactly
the right length.
) p.20 "Creating phrases of a precise length
(Loop Quantize)"
2. Pre Effect section
Here you can control the Pre Effect. The Pre Effect will be
applied to the signal from the INPUT jack and the MIC IN
jack.
The effect will be applied to the input that's selected by the
PRE FX TARGET button.
) p.14 "d. PRE FX TARGET button"
a. Pre Effect selector
This selects the type of Pre Effect.
12
a
b
b. PRE FX button
This turns the Pre Effect on/off.
The button will light-up red when the effect is on, and it will
blink while you're editing the effect.
Note: Turning the effect selector will also pedal the Pre
Effect on.
Hint: You can pedal the Pre Effect on/off by holding down
the STOP pedal and the PROGRAM UP pedal
simultaneously for approximately two seconds.
3. Loop Effect section
Here you can control the Loop Effect. The Loop Effect
applies to the phrases recorded in Loop 1 and Loop 2. You
can use this to change the phrase's pitch ("PITCH" effect), or
mix in a backward playback sound ("REVERSE" effect).
Note: The Loop Effect is available when you're playing back
a phrase that's been recorded in a loop; it will be applied to
the recorded phrase. It will not be applied during recording
or overdubbing.
a
b