VOX Amplification Dynamic Looper Manuel D'utilisation page 13

a. Loop Effect selector
This selects the type of Loop Effect. The type of effect you
select here will be applied.
b. LOOP FX button
This turns the Loop Effect on/off.
The button will light-up green when the effect is on, and it
will blink while you're editing the effect.
Note: Turning the effect selector will also pedal the Loop
Effect on.
4. Control pedal section
You can use this pedal to control the parameters of the Pre
Effect or Loop Effect, or to control the volume.
a. Pedal LED
This LED will be lit or unlit to
indicate the state of the function
that's assigned to the control pedal.
) p.39 "Control pedal settings"
b. Control pedal
This pedal controls the effect
parameter that's assigned to it, or
controls the volume.
For details on how to assign a
function to the pedal, please refer to
"Control pedal settings" on page 39.
For details on the effect parameters
that you can control, please refer to "About the Pre Effect
and Loop Effect" on page 29.
5. Metronome section
Here you can specify the metronome setting and time
signature.
a. METRONOME button
This button turns the metronome sound on/off.
When you press the button, it will blink, and
you'll hear the metronome. The button will blink
in synchronization with the tempo that you
specified using the TRIGGER/TAP pedal.
To adjust the metronome volume, hold down
this button and turn the EDIT knob.
To set the time signature, hold down this button for
a
approximately two seconds and then turn the EDIT knob.
) p.20 "Using the metronome as a guide while you record"
b
Panels
a
13