Publicité
Les langues disponibles
Les langues disponibles
User Manual
PC Control
Download the Matrix Controller software from the LINDY website, this can be found by
searching for 38052 and view downloads. The software is an EXE file, once you have
downloaded it, unpack it from the download and then double click to run.
You must make sure that you have set up the Matrix and connected it to the PC via an RS232
cable or an RJ45 cable on your LAN before using this software.
General
1. Select RS232 or TCP control mode
2. Select the RS232 COM port
3. Click to connect or disconnect the
PC and Matrix
4. Select the Matrix IP address
5. Connect to the Matrix IP address
6. Search the Matrix IP address
7. Configure the Matrix IP and MAC
address
8. Enable or disable the IR and beep
9. Device information display area
10. Click to refresh the data in the
information display area
11. Clear the device information screen
TCP Configuration
1. Select Auto IP or Static IP
2. When choosing static IP, write the
IP address I this area
3. When choosing static IP, write the
MAC address in this area
EDID
1. Click Set when you have chosen the EDID
mode (2) and port (3)
2. Select the EDID from the drop down list
3. Select the port or all from the drop down list
4. Click set when you have chosen the output port
5. Select the output port to copy the EDID from
6. Select set when you have selected where to
download the EDID from
7. Click to select the location of the EDID binary
file
8. Displays the location path
English
Publicité
