Publicité
Les langues disponibles
Les langues disponibles
User Manual
3. Power Button: The button will illuminate green when the Matrix is on and red when in
stand-by mode
4. Lock Button: Press the button once to lock all the buttons on the front panel. Press the
button again to unlock all the buttons. The LED will illuminate red when the lock is active
5. Output Selection Buttons: Select A-F of the output channels or "All"
6. Input Selection Buttons: Select 1-8 of the input channels
7. PTP Button: Press to mirror all inputs to all outputs (Input 1 to Output 1, Input 2 to Output
2 etc.)
8. EDID Control Area:
Rear
1. PC Control:
2. HDMI Input Ports: Connect your HDMI sources and the LED will illuminate when an
active signal is detected
3. HDMI Output Ports: Connect your HDMI displays and the LED will illuminate when an
active signal is detected
4. Power Port: Only use the PSU included to power the Matrix
To control the Matrix using the front push buttons, select the output from A-F or All and then
select the input from 1-8 that you want to show on the output.
To change the input EDID, press the menu button then press up/down till you find the EDID you
want then press enter to enter to the port submenu. Press up/down to select the port you want
and press enter to save your settings.
EDID Mode Table
1. Submenu：EDID mode table
Number
1
2
Menu: Press to enter the EDID set mode
Enter: Press to confirm and save the setting
Up: Press to go up
Down: Press to go down
TCP/IP: Connect an active Ethernet cable for TCP/IP control
RS232: Connect a D-Sub cable to a PC for control with RS232 commands
EDID Description
1080i, 2CH AUDIO
1080i, DOLBY/DTS 5.1
English
Publicité
