Bresser Spezial Jagd 8x56 Mode D'emploi page 11

BINOCULARS
List of Parts
B
Centre axle
C
a Twist-up eyecups
or
C
b Rubber eyecups
D
Dioptre adjustment
E
Body of the binoculars
F
Lens tube
G
Central focussing wheel
H
Eyepiece
I
Objective lens
J
Threaded tripod connection
1)
Image circle with correctly set eye distance
Eyepieces for spectacle wearers
Depending on the model, your binoculars are equipped with either twist-up eyecups (2a) or
rubber eyecups (2b). Since there is a larger distance between the binocular eyepiece and
the pupil for those wearing glasses, both eyecup varieties can be adjusted individually.
Twist-up Eyecups (2a)
Screw in the twist-up eyecups (2a) to use the binoculars while wearing glasses. If you are not
wearing glasses, unscrew the eyecups to achieve the required distance from the pupils.
OR
Rubber Eyecups (2b)
To use the binoculars while wearing glasses, turn the rubber eyecups (2b) towards the sides
and down. If you are not wearing glasses, leave the eyecups in the upright position to achieve
the required distance from the pupils.
Adjusting the eyepiece distance
The distance between the eyes differs between individuals. To achieve perfect interaction
between your eyes and the eyepieces of your binoculars set the angle at the centre of the
binoculars (1) so that you see a circular image (10). Note this setting for later use.
Adjusting the focus
Look through your binoculars with your right eye closed. Now adjust the image for your left
eye using the centre wheel (6) until it is sharp and clear. Close your left eye and adjust the
image for your right eye using the dioptre ring (3) until it too is sharp and clear.
Mounting the binoculars on a tripod
Your binoculars have a threaded tripod connection (9) built in. The required tripod adapter is
available as an optional accessory (Art. No. 19-16000 or 19-16500). With this accessory,
you are able to mount your binoculars on a tripod with a DIN mounting thread (e.g. Art. No.
49-22100).
P R C
P R C
P R C
P R
10