Setting The Temperature; Using The Emergency Switch (Where Fitted); Usb Port For Power Supply - Dometic CoolFreeze CFX 35 Notice D'utilisation

CFX35, CFX50
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 3) down, until it latches in place audibly.
7.6

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 3) once.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN –" (fig. 3 6, page 3)
buttons to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The
display flashes several times and then the current temperature is dis-
played again.
7.7

Using the emergency switch (where fitted)

The emergency switch (fig. 5 1, page 4) is located below the control panel.
For normal operation the switch is in the "NORMAL USE" position.
➤ If an electronic control failure occurs, slide the switch to "EMERGENCY
OVERRIDE" position
I
NOTE
If the switch is in the "EMERGENCY OVERRIDE" position, the
cooler runs with full cooling capacity and may freeze.
7.8

USB port for power supply

USB port allows you to charge small devices like mobile phones and mp3-
players.
To use your cooling box with any USB devices, simply connect a USB cable
(not included) to your device.
I
NOTE
Ensure that any small device connected to the USB port is
compatible with 5 V/500 mA operation.
EN
Operation
19