Energy Saving Tips; Connecting The Cooler - Dometic CoolFreeze CFX 35 Notice D'utilisation

CFX35, CFX50
Selecting the temperature units
Temperature display units can be switched between Celsius and Fahrenheit
as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 3) twice.
➤ Use the "UP +" (fig. 3 7, page 3) or "DOWN –" (fig. 3 6, page 3)
buttons to select Celsius or Fahrenheit.
✓ The selected temperature units then appear in the display for a few
seconds. The display flashes several times before it returns to the current
temperature.
7.2

Energy saving tips

 Choose a well ventilated installation location which is protected against
direct sunlight.
 Allow warm food to cool down first before placing it in the cooling device
to keep cool.
 Do not open the cooling device more often than necessary.
 Do not leave the cooling device open for longer than necessary.
 Defrost the cooler once a layer of ice forms.
 Avoid unnecessarily low temperatures.
7.3

Connecting the cooler

Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
A
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system to
prevent the polarity reversal. This protects the cooler against short-circuiting
when connecting to a battery.
➤ Plug the 12/24 V connection cable (fig. 1 2, page 3) into the device
DC voltage socket and also into a 12 V or 24 V cigarette lighter socket.
EN
.
g
Operation
15