Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SECTION E:
OPERATION
1. Filling Fuel
FF-55T:
• Do not fill the removable tank in the living room, but in a more
suitable place(there can always be some spillage).
• Do not refuel the heater while in operation or still hot.
Follow the procedure below:
1) Make sure that the heater is switched off.
2) Open the tank lid and lift the removable tank out of the heater.
NOTE: Some drops may leak from the tank. Put down the
removable tank (cap pointing upwards) and screw off the
fuel cap.
3) Take the manual fuel pump and insert the smooth, most rigid tube
into the can. Make sure that it is in a higher position than the
removable tank. Insert the ribbed hose into the opening of the
removable tank.
4) Lock the switch button on top of the pump (turn clockwise).
5) Squeeze the pump a few times, until fuel starts flowing into the
removable tank. As soon as this happens, there is no need to press
any longer.
6) Check the removable tank fuel gauge while filling the tank. Stop
filling by loosening the switch button on top of the pump (turn anti-
clockwise), once the gauge indicates that the tank is full. Never
overfill the tank, especially not when the fuel is very cold (fuel
expands when it heats up).
7) Let the remaining fuel in the pump flow back into the can and carefully remove the pump. Carefully screw the
fuel cap back on the tank. Clean off any spilled fuel.
8) Check whether the fuel cap is straight an tightened properly. Reinstall the removable tank in the heater (cap
down). Close the tank lid.
FF-55:
1) Open the Valve(s)
Open the valve(s) of the external fuel tank.
2) Start the Fuel flow
If using heater for the first time, press the red reset button in order to send fuel to the
fuel sump and release.
NOTE: Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
2. Connect the Heater
Connect heater into a proper electrical outlet. (refer to SECTION A).
On digital indicator pre-set "Two Dashes" will be showing.
NOTE: Do not connect to an outlet shared with other appliances.
3. Set Clock
IMPORTANT: Clock on the heater must always
NOTE: In the event of a power failure (more
than approx. 30 min.), all clock and day
may be cancelled.
4. Setting of the Time and a Day of the Week.
1) Setting of the current time
1. Press the "sMIN." button to set minutes and press the "tHOUR" button to set hours while in not
operation.
2. Press the "SET" button to complete the set of the current time.
2) Setting of a day of the week
,
1. "dAy" sign is shown on the display and all of a day of the week will flash.
Press the "sMIN." button or the "tHOUR" button to set a day of the week.
5
BEFORE IGNITION
be set to current time and day.
ENGLISH
empty
full
Red Reset
Button
Publicité
Table des Matières
