Toyotomi FF-55T Manuel D'utilisation page 7

NOTE: When pressing the "sMIN." button at the position of "SAT", you
can hear the beep sound and "SAT" is not changed any more.
When pressing the "tHOUR" button at the position of "SUN", you can
hear the beep sound and "SUN" is not changed any more.
2. Press the "SET" button to complete the set of a day of the week.
The current time and the day of week will show on the display.
MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically adjusted
in accordance with the room temperature registered by the temperature sensor.
1. Turning Heater ON
1. Press ON/OFF switch to "ON" position. The current room temperature and the set temperature will be shown
on the digital indicator. ON lamp will start to flash and then blower motor and ignition will start. This lamp will
continue to flash during the preheating time.
2. After approx. 1.5 – 4 minutes ignition will take place. (*) After ignition, ON lamp will change flashing to
continuous. Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Pre -heating depends on the
room temperature.
Room temperature:
under 0˚C 4
0˚C - 15˚C 2
15˚C 1.5
2. Adjusting Room Temperature
1. Press "sMIN." or "tHOUR" button. ˚F or ˚C will start to flash.
2. Press "sMIN." or "tHOUR" button as required. Room temperature can be set from 10˚C (50˚F) to 32C (90˚F).
(Initial setting : 13˚C (56˚F))
Desired temperature setting will be displayed on the digital indicator when you set the room temperature.
When room temperature reaches the selected setting, heater will automatically shift to "MED" or "LOW"
burning mode to maintain the desired temperature.
Whe n room te mpe rature exce e ds the
selected set ting by approx. 2 ˚C (4˚ F ),
the heater will automatically shut off. As
room temperature drops, the heater will
automatically re -star t to maintain the
desired temperature.
POWER SAVER OPERATION
The Power Saver mode reduces the frequency
of ignition actions, to save electric consumption.
1. Press the POWER SAVER (DAY SELECT)
button "ON" while in operation to start
the operation of the "POWER SAVER".
"POWER SAVER" sign will be shown on
the digital indicator. When the room tem-
perature exceeds the selected setting by approximately 6˚C (10˚F), the heater will automatically shut off.
As the room temperature becomes lower than the selected setting, the heater will automatically re-start to
maintain the desired temperature.
FUEL INDICATOR LIGHT (FF-55T)
When the information display lights up, fu 10 , it means that there is only fuel left for 10 more minutes. The count
down of the remaining heating time can be seen in the information display. You remove the fuel tank and refill
it outside the living room. If you don't refill it,you will hear an alarm signal every two minutes, warning you to
refill the removable tank. After 10
minutes the information display,
fu el , blinks and the heater will
switch off automatically.
OPERATION
minutes
minutes
minutes
ENGLISH
,
6