Important - Sennheiser FreeSound RS2400 Notice D'emploi

AUTOMATIC ON/OFF SWITCHING
The transmitter features a convenient automatic on/off function. When an audio signal reaches the
·
transmitter, it is switched on and the LED
also indicates that an accupack is being recharged. When a stethoset receiver or an accupack is inserted
into a charging compartment, the LED lights up red.
Green LED = Transmitter ON
Yellow LED = Transmitter ON, Accupack recharging
Red LED = Accupack recharging
LED not lit = transmitter OFF
If there is no audio signal for about 3 minutes, the transmitter automatically switches off. The transmitter
is now in stand-by mode, its power consumption is very low so that it can remain connected to the mains.

IMPORTANT

The transmitter's charging function (charging compartments
on/off function. Accupacks can always be recharged when the transmitter is connected to the mains.
When you are not going to use the transmitter for some time (e.g. when you are on holiday), you should
unplug the mains unit and take the stethoset receiver and the accupack out of their respective charging
compartments.
ADJUSTMENTS ON YOUR TV SET
Please refer to the instruction manual of your TV set to find out whether the volume control also adjusts
the headphone output or whether this output has a separate volume control. You will also find
instructions on how to switch off the main loudspeakers.
OPTIMUM MODULATION LEVEL OF THE TRANSMITTER
First, set the volume of your TV set to a medium value.
at the front of the transmitter lights up green. The LED
³ and ») is independent of the automatic
·
17