Putting The Transmitter Into Operation - Sennheiser FreeSound RS2400 Notice D'emploi

WHERE TO PLACE THE TRANSMITTER
Choose a suitable place near your TV set.
ATTENTION!
Some furniture surfaces have been treated with varnish, polish or synthetics which might cause stains when
they come into contact with other synthetics. Despite a thorough testing of the synthetics used by us, we
cannot rule out the possibility of discolouration, since we don't know your furniture. You should therefore
always place the transmitter on a non-slip pad.

PUTTING THE TRANSMITTER INTO OPERATION

Use the supplied cable to connect socket
source. The cable is fitted with a 3.5 mm jack plug suitable for most headphone sockets. For connection
to 1/4" (6.3 mm) headphone sockets, use the supplied adaptor.
Connect the plug-in mains unit to socket
ANTENNA
The wire antenna is an integral part of the
transmitter. For best transmission the antenna
should be vertical. You can therefore
leave the wire antenna dangling in a vertical
position down behind the transmitter or
(the better option) slide the supplied plastic tube
over the antenna and snap it into the clamp at the
back of the transmitter.
Make sure that there are no metal objects such as
shelf bars or lamp stands in parallel with the antenna.
Do not place the transmitter on your TV set as it might
interfere with the transmitter. Test where exactly in
the room the transmitter works best.
16
º
on the transmitter to the headphone socket of your sound
¾
on the transmitter and plug the mains unit into a wall socket.